PEGASO BCJA620L11

Product code P925205 00004

Electromechanical operator, deadman, for industrial sectional doors with max surface area 20 m² and use Semi intensive. Power supply 230 V. max speed 33 Rpm. max torque 50 Nm. Chain release. IP54

Main features
  • Management system for stop and intermediate limit switches based on absolute encoder technology with settable zero position.

  • Control unit with deadman feature on-board operator

  • Ready-to-use cables with quick-fit connectors.

Recommendation

Attention: To benefit from the official warranty on Bft products purchased online, you must check that the retailer is approved by Bft.

Report a suspicious product or e-partner
technical design
Nominal voltage 230 V
Power consumption 750 W
Max surface area 20 m²
Door surface area 20 m²
Type of limit switch Absolute encoder
Locking Mechanical
Release Chain release
Frequency of use Semi intensive
Protection rating IP54
Environmental conditions -10 ÷ 50 °C
Interconnectivity no
Shaft diameter 25.4 mm
Travel 18
PEGASO CABLE MONO
D121631

Pre-wired power supply cable for PEGASO single phase operators. Length 1 m

PEGASO CABLE TRI
D121632

Pre-wired power supply cable for PEGASO three-phase operators. Length 1 m

PEGASO UP CONTROL 5
D121624

Cable with pre-wired OPEN - STOP - CLOSE keypad for PEGASO UP operators. For adjusting motor limit switches from floor level. Length 5 m

PEGASO UP CONTROL 10
D121625

Cable with pre-wired OPEN - STOP - CLOSE keypad for PEGASO UP operators. For adjusting motor limit switches from floor level. Length 10 m

PEG CCP
N999468

Extension for PEGASO C operators release chain. Length 4 m

PIG 12/ULISSE S
N733338

Z12 pinion gear for reduction on industrial sectional doors, for 1 " (25.4 mm) shafts

PIG 14/ULISSE S
N733336

Z14 pinion gear for reduction on industrial sectional doors, for 1 " (25.4 mm) shafts

PIG 18/ULISSE S
N733339

Z18 pinion gear for reduction on industrial sectional doors, for 1 " (25.4 mm) shafts

PIG 30/ULISSE S
N733337

Z30 pinion gear for reduction on industrial sectional doors, for 1 " (25.4 mm) shafts

COR 30
N733148

Z30 gear kit with accessories for industrial sectional doors, for 1 " (25.4 mm) shafts

COR 40
N733149

Z40 gear kit with accessories for industrial sectional doors, for 1 " (25.4 mm) shafts

SFZ
N733121

Additional fixing bracket kit. To be used on chain drive installations.

PEGASO ADA
N733449

PEGASO ADA adapter for installation on doors with 1"1/4 shaft

An unexpected error occurred: please reload the page or try again later.