PEGASO BCJA645W11

Produkta koda P925203 00007 Starptautiskais kods 2611568

Electromechanical operator, deadman, for industrial sectional doors with max surface area 45 m² and use intensive. Power supply 400 V. max speed 24 Rpm. max torque 100 Nm. Chain release. IP54

Pāriet uz rokasgrāmatām

Galvenās iezīmes

Management system for stop and intermediate limit switches based on absolute encoder technology with settable zero position.

Control unit with deadman feature on-board operator

Ready-to-use cables with quick-fit connectors.

Tehnisko datu lapas

techninis brėžinys
Nominal voltage 400 V
Power consumption 980 W
Max surface area 45 m²
Door surface area 45 m²
Type of limit switch Absolute encoder
Locking Mechanical
Release Chain release
Frequency of use intensive
Protection rating IP54
Environmental conditions -10 ÷ 50 °C
Interconnectivity no
Shaft diameter 25.4 mm
Travel 18
Pāriet uz rokasgrāmatām

Ieteiktie piederumi

PEGASO CABLE MONO
D121631

Pre-wired power supply cable for PEGASO single phase operators. Length 1 m

PEGASO CABLE TRI
D121632

Pre-wired power supply cable for PEGASO three-phase operators. Length 1 m

PEGASO UP CONTROL 5
D121624

Cable with pre-wired OPEN - STOP - CLOSE keypad for PEGASO UP operators. For adjusting motor limit switches from floor level. Length 5 m

PEGASO UP CONTROL 10
D121625

Cable with pre-wired OPEN - STOP - CLOSE keypad for PEGASO UP operators. For adjusting motor limit switches from floor level. Length 10 m

PEG CCP
N999468

Extension for PEGASO C operators release chain. Length 4 m

PIG 12/ULISSE S
N733338

Z12 pinion gear for reduction on industrial sectional doors, for 1 " (25,4 mm) shafts

PIG 14/ULISSE S
N733336

Z14 pinion gear for reduction on industrial sectional doors, for 1 " (25,4 mm) shafts

PIG 18/ULISSE S
N733339

Z18 pinion gear for reduction on industrial sectional doors, for 1 " (25,4 mm) shafts

PIG 30/ULISSE S
N733337

Z30 pinion gear for reduction on industrial sectional doors, for 1 " (25,4 mm) shafts

COR 30
N733148

Z30 gear kit with accessories for industrial sectional doors, for 1 " (25,4 mm) shafts

COR 40
N733149

Z40 gear kit with accessories for industrial sectional doors, for 1 " (25,4 mm) shafts

SFZ
N733121

Additional fixing bracket kit. To be used on chain drive installations.

PEGASO ADA
N733449

PEGASO ADA adapter for installation on doors with 1"1/4 shaft

Vai jums ir nepieciešams vairāk informācijas?

Lūdzu, sazinieties ar mums, un mūsu atbalsta komandas dalībnieks jums atbildēs, tiklīdz varēs.

Rakstiet mums

Radusies neparedzēta kļūda: lūdzu, ielādējiet lapu atkārtoti vai mēģiniet vēlreiz vēlāk.