WIND RMC 445B 240-230 EF

Product code P910040 00002

Operator for shutters with spring holder pulley diam. 101 mm. Max. torque 445 Nm and absorbed power 1200 W. Release with steel cable and knob for electric brake.

Main features
  • Simple and intuitive adjustment of limit switches

  • Adapters for 42 or 48 (RMB) or 76mm (RMC) shafts included in the pack

Assistance

Attention: To benefit from the official warranty on Bft products purchased online, you must check that the retailer is approved by Bft.

Report a suspicious product or e-partner
technical design
Control unit ELBA/ELBA BU
Power supply 230 V
Power consumption 1200 W
Shaft diameter 101 mm
Spring holder diameter 240 mm
Maximum torque 445 Nm
Rotation speed 8 Rpm
Type of end switch
Locking Electric brake
Impact reaction no
Protection rating IP20
Environmental conditions -10 ÷ 50 °C
Interconnectivity no
Recommended
ELBA
ELBA BU
Compatible
ALPHA SD
SHEDIR B CBC 02 L01
Cod. P111515

Control unit for wired centralisation. For 2 operators (or 2 groups of operators) Application: wire centralisation board for 1 or 2 tubular motors Card power supply: 230 V single-phase Operator power supply: 230V 600W max. each operator Main characteristics: simplified and compact wire centralisation system Functions: control of 1 or 2 motors (or motor units) in single or simultaneous mode, general up/down, motor 1 or unit 1 up/down, motor 2 or unit 2 up/down

Control unit for wired centralisation. For 2 operators (or 2 groups of operators) Application: wire centralisation board for 1 or 2 tubular...

ELBA
Cod. D113716 00002

Control panel, max 230V, for roller shutters or roll-up doors Application: control panel for REEL type operator for roller shutters Card power supply: 230 V single-phase Operator power supply: 230V monophase Main features: Extremely compact size for installation in shutter case, programming with potentiometers and dip switches, built-in receiver Main functions: separate open/close, photocells input, possibility of centralised controls, anemometer and twilight sensor management Compatibility: CAPRI, CAPRI RIC, CAPRI TCA

Control panel, max 230V, for roller shutters or roll-up doors Application: control panel for REEL type operator for roller shutters Card...

COMPACTA A20-180
Cod. P111782

Pair of photocells adjustable 180 ° horizontally. Range 20m. Power supply 12 – 33Vac / 15 – 35Vdc

BOX
Cod. N574039

Wall cabinet for release with steel cable and electric control; cable not included

X EF1
Cod. N999510

Electric brake for Wind Rmc and Rmb 230V

This website uses profiling cookies (own and of other websites) for the purpose of sending advertising messages in line with the preferences expressed by the user in the context of web browsing. By continuing to browse or by accessing any element of the website without changing the cookie settings, you implicitly accept to receive cookies on our website. The settings of the cookies can be changed at any time by clicking on Information or using the Privacy link located at the bottom of the page.

An unexpected error occurred: please reload the page or try again later.