230 V hydraulic bollard, shaft height 600 mm and diameter 273 mm. LED light cap and H adhesive strip: 100 mm, certified. In the event of a power cut, the bollard remains raised. Foundation box included.
Attention: To benefit from the official warranty on Bft products purchased online, you must check that the retailer is approved by Bft.Report a suspicious product or e-partner
This solution, included in the range of Bft hydraulic bollards, allows quick maintenance without the use of a shaft lifting crane.
|Control unit||PERSEO CBE 230.P SD|
|Opening or closing time||5 s|
|Rod height||600 mm|
|Rod thickness||6 mm|
|Type of limit switch||REED magnetic sensor|
|Impact resistance||20000 J|
|Break-in proof||250000 J|
|Manual cycle||Release key|
|Frequency of use||3000 Op/gg|
|Environmental conditions||-40 ÷ 60 °C|
|Rod treatment||316L stainless steel|
|Power supply||230 V|
|Rod diameter||273 mm|
Base module for TOTEM. Can be used as either the lower or upper module. Used to install the control accessories. Top cover not included....