PEGASO BCJA625L11

Product code P925203 00006

Electromechanical operator, deadman, for industrial sectional doors with max surface area 25 m² and use Semi intensive. Power supply 230 V. max speed 24 Rpm. max torque 70 Nm. Chain release. IP54

Main features
  • Management system for stop and intermediate limit switches based on absolute encoder technology with settable zero position.

  • Control unit with deadman feature on-board operator

  • Ready-to-use cables with quick-fit connectors.

Assistance

Attention: To benefit from the official warranty on Bft products purchased online, you must check that the retailer is approved by Bft.

Report a suspicious product or e-partner
technical design
Nominal voltage 230 V
Power consumption 750 W
Max surface area 25 m²
Shaft diameter 25.4 mm
Door surface area 25 m²
Travel 18
Type of limit switch Absolute encoder
Locking Mechanical
Release Chain release
Frequency of use Semi intensive
Protection rating IP54
Environmental conditions -10 ÷ 50 °C
Interconnectivity no
PEGASO CABLE MONO
Cod. D121631

Pre-wired power supply cable for PEGASO single phase operators. Length 1 m

COMPACTA A20-180
Cod. P111782

Pair of photocells adjustable 180° horizontally. 20 metre range. 12-33 VAC/15-35 VDC power supply.

PEGASO CABLE TRI
Cod. D121632

Pre-wired power supply cable for PEGASO three-phase operators. Length 1 m

PEGASO UP CONTROL 5
Cod. D121624

Cable with pre-wired OPEN - STOP - CLOSE keypad for PEGASO UP operators. For adjusting motor limit switches from floor level. Length 5 m

PEGASO UP CONTROL 10
Cod. D121625

Cable with pre-wired OPEN - STOP - CLOSE keypad for PEGASO UP operators. For adjusting motor limit switches from floor level. Length 10 m

PEG CCP
Cod. N999468

Extension for PEGASO C operators release chain. Length 4 m

PIG 12/ULISSE S
Cod. N733338

Z12 pinion gear for reduction on industrial sectional doors, for 1 " (25.4 mm) shafts

PIG 14/ULISSE S
Cod. N733336

Z14 pinion gear for reduction on industrial sectional doors, for 1 " (25.4 mm) shafts

PIG 18/ULISSE S
Cod. N733339

Z18 pinion gear for reduction on industrial sectional doors, for 1 " (25.4 mm) shafts

PIG 30/ULISSE S
Cod. N733337

Z30 pinion gear for reduction on industrial sectional doors, for 1 " (25.4 mm) shafts

COR 30
Cod. N733148

Z30 gear kit with accessories for industrial sectional doors, for 1 " (25.4 mm) shafts

COR 40
Cod. N733149

Z40 gear kit with accessories for industrial sectional doors, for 1 " (25.4 mm) shafts

SFZ
Cod. N733121

Additional fixing bracket kit. To be used on chain drive installations.

PEGASO ADA
Cod. N733449

PEGASO ADA adapter for installation on doors with 1"1/4 shaft

This website uses profiling cookies (own and of other websites) for the purpose of sending advertising messages in line with the preferences expressed by the user in the context of web browsing. By continuing to browse or by accessing any element of the website without changing the cookie settings, you implicitly accept to receive cookies on our website. The settings of the cookies can be changed at any time by clicking on Information or using the Privacy link located at the bottom of the page.

An unexpected error occurred: please reload the page or try again later.